Happy Friday....
This week i have some Christmas cards to share with you, I'm not normally a card maker, and i tend to struggle wiht cards, but here they are, I actually really like how they turned out
Here is a quick little tutorial on how i made my flowers..
I cut two of each of three sizes of flower from my Tim Holtz Tattered Garland die. I have used some older Prima papers-from the North Country Range
Using a piece of foam or something soft and the round tip of a sharpie pen ( or something small and rounded on the end), work each petal in a circular motion until it curls up.. medium pressure is good. It does take a little while to do all your flowers.
I put each flower into the palm of my hand and manipulate it a little more until it's just right. I started with my bigger petals, and put a small drop of glue in each one as i layered them all in on top of each other, from largest to smallest.Also make sure you offset the petals when assembling them so they dont all line up.
Products Used:
Nrth Country - Wonderland- I cut the reindeer out
North Country - Snow Fall - I used this for the card base
North Country 8x8 paper Pad
Tim Holtz Tattered Flower Garland Die - Currently out of stock
